AUDIO CONTROL

LC6-I


6-channel line output converter for adding outboard amps to your factory audio system

Features

Speaker Input: The speaker level inputs are compatible with nearly any factory stereo system, even most Bose systems. There are 3 pair of inputs that will accommodate up to 400 watts.

Channel Summing: The LC6i has the ability to sum together multiple input channels (4 or 6) from the factory source unit into 2 channels. This is handy when the factory system has multiple, actively crossed-over signals sent from the OEM source unit or amp(s). For example, in some vehicles there is an actively crossed-over tweeter, midrange, and woofer all in the front of the vehicle. The LC6i lets you take all of those signals and sum them together to get a high-quality, full-range, pre-amp signal without the use of any additional cables or hardware.

AutoMode Inputs: When there is no signal present at the channel 3 input, the channel 2 input automatically feeds the channel 2 and channel 3 outputs.

Output Level: The +/- 12 dB output level allows you to adjust the head unit's voltage to the top of your amp's input range; up to 9.5 volts RMS. Each of the three pair of  RCA outputs has its own level adjustment.

Auto Turn-on: The main speaker level input has a signal sensing circuit; the unit turns on when there's a speaker level input signal and turns off when the signal disappears.

Remote Output: The +12 volt DC remote output will trigger an amp to turn on whenever the LC6i is on. The remote's maximum current output is 1 amp.

Optional Sub Level Control: With the addition of an optional wired remote, sold separately), you can easily adjust the output level of channel 3, often used for a subwoofer.

Ground Isolation: The power supply ground is switchable, in case of ground loop noise. The factory position is fully isolated (typically the best choice), but can be changed to Ground or 200Ω.

Terminal Blocks: The power/ground/remote in/remote out terminal and the speaker level input terminals are removable; the wiring is attached to the block, then the block is plugged into the LC6i. The terminal blocks will accommodate wire up to 12 gauge.

Specifications:

 

  • Maximum Speaker Level Input: 400 watts
  • Maximum Output Voltage: 9.5 volts RMS
  • Frequency response: 10Hz-22kHz
  • THD: 0.01%
  • Input Impedance: 20 kΩ